MDT .308 Metal Magazine 10rnd
MDT AICS-pattern metal magazines are manufactured from high strength steel and nitride-finished for ultimate durability. These magazines are designed as a Double Stack Single Feed (DSSF) pattern for reduced overall height compared to the industry standard.
MDT AICS-pattern metal magazines are manufactured from high strength steel and nitride-finished for ultimate durability. The short action magazines are offered for .308 Win and 6.5 Creedmoor family cartridges, and are available in 5-round and 10-round capacity.
These magazines are designed as a Double Stack Single Feed (DSSF) pattern for reduced overall height compared to the industry standard.
The 10-round magazines are available with or without the front binder plate. See details below for benefits and limitations of each version.
Please note that this product may require an export permit in order to be shipped from Norway. Please upload a scanned copy of your ID card or similar when placing your order. This notice does not apply to customers in Norway
MDT AICS-pattern metal magazines are manufactured from high strength steel, nitrided, and finished inside and outside with Cerakote for ultimate durability, corrosion resistance, and friction reduction.
- 3.055” Outside Length
- 2.870” max cartridge overall length (COAL) with binder plate
- 2.960” max cartridge overall length (COAL) without binder plate (see limitations below)
- 3.90” Rear Height
The 10-round magazines are approximately ¾” shorter in height than standard AICS 10-round magazines due to the Double Stack Single Feed (DSSF) design, allowing easier mag changes when shooting prone.
The 10-round magazine includes 2 internal ribs that help reduce friction between the cartridge and magazine body and provide a smooth transition from a double stack to single feed at the top of the magazine.
Binder Plate Details:
- The magazines with front binder plates are compatible with all rifles equipped with AICS-pattern bottom metal or chassis systems. The binder plate holds the cartridges back from the front of the magazines and guides them past the bottom of the feed ramp. The maximum cartridge overall length (COAL) that will fit in this magazine is 2.870”.
- The magazines without front binder plates allow a maximum cartridge overall length of 2.960”. These are compatible with all AICS-pattern bottom metal and chassis systems, but most common actions such as Remington 700 and Savage 10/11 will require modifications to the receiver (i.e. notching out the bottom of the feed ramp) to prevent the bullet tips from catching on the bottom of the feed ramp (see photo below). DO NOT order these magazines without a full understanding of this.
|Bipod feet type||No|
|Bipod mount type||No|